Up and Configure Hikvision IP Intercom System
Setting up a Hikvision IP Intercom system is a straightforward process that involves specific cabling requirements and configuration steps. Below is a comprehensive guide to help you through the setup.
Cabling Requirements
-
Ethernet Cables:
- Run an Ethernet cable from each Door Station to a PoE Switch.
- Connect each Indoor Monitor to the PoE Switch with an Ethernet cable.
- Use an Ethernet cable to connect the PoE Switch to your modem if you want to enable remote communication.
-
Control for Gates:
- If you need to control one or two door or gate strikes, run 4-core cabling from the Intercom Door Station to the respective strikes.
- Note that these strikes require separate power sources since the door station cannot power them.
Step-by-Step Configuration
-
Power On Devices:
- Ensure all devices (Door Stations, Indoor Monitors, and the PoE Switch) are properly powered and connected.
-
Access the Intercom Configuration:
- Using a web browser on a PC connected to the same network, enter the IP address of the Door Station or Indoor Monitor to access their configuration interfaces.
-
Set Up Network Settings:
- Configure the IP settings for each device to ensure they are on the same subnet for seamless communication.
- Consider enabling DHCP for automatic IP assignment or set static IPs based on your network design.
-
Configure Intercom Features:
- Within the configuration interface, customize settings such as device names, ringtones, and volume levels to suit your preferences.
-
Link Devices:
- Ensure all Indoor Monitors are linked to the respective Door Stations. This can usually be done in the settings of the camera or monitor interface.
-
Test the System:
- After configuration, conduct tests to verify that communication between the Door Stations and Indoor Monitors is working correctly. Check the video and audio quality.
-
Remote Access Configuration (Optional):
- If you wish to enable remote access via the Hik-Connect app, make sure to configure the necessary port forwarding on your router and link the devices to your Hik-Connect account.
ONE DOOR STATION AND ONE MONITOR – in case the first video was too fast. Set up is quick and easy and doesn’t use IVMS4200.
THE MOST USEFUL GUIDES FROM HIKVISION
HOW TO CONFIGURE DOOR STATION AND EXTENSION VIA LOCAL INTERFACE
Conclusion
By following these steps, you can successfully set up and configure your Hikvision IP Intercom system for effective communication and monitoring.
For additional resources, including setup videos and detailed guides, refer to the official Hikvision User Manual.
If you have further questions or need assistance with your installation, feel free to reach out for support!