How can I log into a Hikvision IP camera linked to an NVR?

If you need to configure your Hikvision cameras, follow these step-by-step instructions to access the camera settings through their IP addresses, using the SADP tool.

Steps to Access Your NVR and Cameras

Step 1: Open the SADP Tool

  • Launch the SADP program. If you haven't downloaded it yet, you can get it here. The SADP tool will display the IP address of your NVR, which you will find next to the NVR model number.

Step 2: Access the NVR via a Web Browser

  • Open an internet browser and enter the IP address of the NVR in the address bar.
  • Note: Some browsers may encounter plugin issues with live view. If this occurs, you may need to use the IE Tab extension for Chrome, available at the Chrome Web Store.

Step 3: Log In to the NVR

  • Enter the username and password for the NVR to access the settings.

Step 4: Enable Virtual Host

  • Navigate to Configuration > Network > Advanced Settings > Other.
  • Check the box to Enable Virtual Host to ensure camera links are available.

Step 5: Access Camera Management

  • Go to Configuration > System > Camera Management. Click on the blue link next to the camera you want to access.

Step 6: Log Into the Camera

  • Use the same username and password as the NVR to log into the camera.

You are now logged into the camera and ready to configure its settings.

Additional Steps if Initial Access Fails

If the above steps do not work, try the following procedure:

Step 1: Connect Your PC to the Camera

  • Use an Ethernet cable to connect your PC directly to the camera port. If you have a 4-channel NVR with 4 cameras, you will need to unplug one camera and connect your PC.

Step 2: Open the SADP Tool

  • Launch the SADP tool again; it should now display all the IP addresses of the cameras.

Step 3: Adjust the PC’s Network Settings

  • Change the subnet and gateway of your PC to match that of the cameras. Ensure the IP address is in the same network range.
  • Right-click on your active connection, go to Properties, select Internet Protocol Version 4 (TCP/IPv4), and adjust these settings accordingly.

Step 4: Enter the Camera IP Address

  • Finally, input the IP address of the camera into the web browser. If your settings from Step 3 were correct, you should be able to log in successfully.

If you have any further questions or need assistance, feel free to reach out!

Leave a comment

Back to blog