How do I reset the AX PRO panel using the reset button

If you need to reset your AX PRO panel to its factory settings, you can easily do so with the reset button. Here’s a step-by-step guide on how to perform the reset:

Step-by-Step Instructions

1. Locate the Reset Button:

   • Find the reset button on the AX PRO panel. This is usually a small pinhole button located on the device.

2. Power Off the Panel:

   • Disconnect the power supply or unplug the device to turn it off completely.

3. Press and Hold the Reset Button:

   • While the panel is powered off, press and hold the reset button.

4. Power On the Panel:

   • While continuing to hold down the reset button, reconnect the power supply or plug the panel back in.

5. Continue Holding the Reset Button:

   • Keep the reset button pressed for about 10-15 seconds after powering on the device.

6. Release the Reset Button:

   • After the specified time, release the reset button. The panel should begin thefactory reset process.

7. Wait for the Reset to Complete:

   • Allow the panel to reboot. Once it restarts, it will be restored to its original factory settings.
     
     How do I reset the AX PRO panel using the reset button

Conclusion

By following these steps, you will successfully reset your AX PRO panel to factory settings, removing all previously saved configurations.

For more detailed instructions and additional resources, refer to the official Hikvision User Manual which provides comprehensive information on your AX PRO device.

If you have any further questions or need assistance, please feel free to reach out!