What’s the best way to install a new HiLook CCTV system?

Congratulations on your purchase of a Hilook IP kit! Here’s a simple guide to get you started on setting up your system.

What You Will Need:

  • Hilook Camera(s)
  • Hilook NVR
  • Pre-crimped CAT5E/CAT6 Cables (1 for each camera, plus 1 from the NVR to the modem). You can also engage an installer who can provide these with RJ45 ends.
  • Monitor or TV (with VGA or HDMI connections). A 22" 1080p monitor can be purchased from retailers like Officeworks for around $110.

Step-by-Step Setup Instructions:

  1. Run the CAT6 Cables:

    • Position a CAT6 cable at each camera location.
    • Collect all cables and route them back to where your NVR will be installed.

  2. Connect the Cameras:

    • Attach one end of each CAT6 cable to the corresponding cameras.
    • Connect the other end of the cables to the NVR.
    • Use electrical tape to seal all cable connections to protect against water damage.

  3. Connect the Monitor:

    • Employ a VGA or HDMI cable to link the monitor to the NVR.

  4. Connect to the Modem:

    • For remote viewing capabilities, connect an Ethernet cable from the NVR to your modem.

  5. Power On the NVR and Monitor:

    • Turn on the NVR and the monitor. You should see a setup screen appear.

  6. Set Up the System:

    • Follow the on-screen prompts to complete the setup. Make sure to record the username and password you create, as resetting them later can be challenging.

  7. View Your Cameras:

    • After configuration, your cameras will be displayed on the monitor screen.

  8. Set Up Remote Viewing:

    • For instructions on enabling remote viewing, refer to our guide on Remote Viewing Setup.
    • If you encounter issues, it may involve your modem settings or other technical aspects. Consider consulting with an IT professional if necessary.

Troubleshooting:

  • Check our troubleshooting resources in the FAQs section.
  • You may also find helpful solutions by searching on Google or YouTube for specific problems.

By following these steps, you can smoothly set up your Hilook IP kit and begin monitoring your environment. If you have any further questions or need assistance, feel free to reach out for support!

Leave a comment

Back to blog