How do I connect cameras to an NVR using a PoE switch and bridge

Cameras to a Network Video Recorder (NVR) Using a PoE Switch and Point-to-Point Network

Expanding your CCTV system by adding cameras to a Network Video Recorder (NVR) through a point-to-point network and a Power over Ethernet (PoE) switch is a practical and efficient method. Follow this step-by-step guide to set up your system seamlessly.

Materials Required:

  • Network Video Recorder (NVR) with available PoE ports.
  • PoE Switch with adequate ports for the number of cameras you plan to install.
  • IP Cameras that support PoE functionality.
  • Ethernet Cables for connecting the cameras and the PoE switch to the NVR.
  • Monitor (if your NVR does not include a built-in display).

Step 1: Prepare the Hardware

  1. Position the NVR:

    • Set up the NVR in a location with good ventilation and access to power.

  2. Install the PoE Switch:

    • Place the PoE switch in a convenient location, ideally close to the NVR.

  3. Mount the IP Cameras:

    • Install the IP cameras at the desired monitoring locations, ensuring they provide a clear view of the areas you wish to observe. Use appropriate mounting accessories as required.

Step 2: Connect the PoE Switch to the NVR

  • Utilize an Ethernet cable to connect one of the LAN ports on the PoE switch to an available LAN port on the NVR. This connection facilitates communication between the cameras and the NVR through the PoE switch.

Step 2.5: Set Up a Point-to-Point Bridge

  1. Select a Point-to-Point Bridge:

    • Choose a bridge that can handle the required range and bandwidth for your setup. Typically, these bridges come in pairs, with one for each end of the wireless link.

  2. Install the First Bridge:

    • Place one bridge near the NVR and connect it to a LAN port on the NVR using an Ethernet cable.
    • Power on the bridge and configure it according to the manufacturer’s guidelines. Set up wireless parameters, including SSID, security settings, and channel.

  3. Install the Second Bridge:

    • Position the second bridge near the PoE switch and connect it to a LAN port on the PoE switch using another Ethernet cable.
    • Power on the second bridge and configure it to match the wireless parameters of the first bridge, ensuring both bridges are set to point-to-point mode.

  4. Establish the Link:

    • With both bridges configured, they will create a wireless connection between the NVR and the PoE switch, functioning as if they were connected by Ethernet cable.

Step 3: Connect the IP Cameras

  • Proceed to connect the IP cameras to the available ports on the PoE switch using Ethernet cables.

Step 4: Power Up Equipment

  • Turn on the NVR, PoE switch, and IP cameras.

Step 5: Configure the IP Cameras on the NVR

  • Access the NVR interface to configure the settings for each connected IP camera, making sure they are properly integrated into the system.

Utilizing a point-to-point bridge allows for greater flexibility in camera placement while reducing the need for extensive Ethernet cabling. Ensure that the bridge provides sufficient signal strength and stability for reliable video feeds.

For more detailed information and resources, refer to the Dahua NVR User Manual. This document includes comprehensive setup instructions and troubleshooting tips for your NVR.

By following these steps, you can efficiently add cameras to your NVR, enhancing your surveillance capabilities. If you have further questions or require assistance, feel free to contact us for support.

Leave a comment

Back to blog