How to Configure Acusense Cameras?

This quick guide shows you how to set up an accurate perimeter guarding system and continuous/event recording with an AcuSense camera and AcuSense NVR or a normal IPC and an AcuSense NVR.

STEP 1 - Log into your camera via your NVR via a web browser. Follow the steps in this link below. These acusense operations are only available on the camera and not the NVR, so this step is important.

Open up SADP program (download here – https://securityaustralia.com.au/faqs/hikvision-sadp-tool-can-download/ SADP will give you the IP address of the recorder . You should see the IP address next to the NVR model number.

Step 2

Open up an Internet browser eg. internet explorer and type in the IP address of the NVR. The IP address of the NVR is obtained in step 1.

Step 3

Log in using username and password of the recorder.

Step 4

Go to Configuration > Network > Advanced Settings > Other.

Tick “Enable Virtual Host”

Step 5

Go to Configuration > System > Camera Management > Click on the blue link next to the camera you wish to log into.

Step 6

Log into the camera. (same username / password as the NVR if the NVR activated the camera)

There you have it – you’re now logged into the camera and ready to perform actions on the camera.

NOW YOU CAN COMMENCE PART 2.

ACUSENSE Step 1. Go to Event > Basic event and disable motion detection. ONLY SMART EVENT TO BE USED WITH ACUSENSE CAMS

Step 2 - Go to Event > Smart Event, Use Line Crossing detection to draw lines. Choose Human and Vehicle as appropriate. Note - if you can't see live view, please download - https://chrome.google.com/webstore/detail/ie-tab/hehijbfgiekmjfkfjpbkbammjbdenadd
Step 3 - Go to the Linkage method tab and select Flashing Alarm / Audible alarm. Notify Suveillance Centre should be checked.
Step 4 - Go to BASIC Event > Flashing Alarm Light Output > Select Schedule (this is the schedule of when to flash lights.
Step 5 - Audible Alarm Output - select a warning sound and set the schedule for this.
https://www.youtube.com/watch?v=9X1_hJJeCwg
Hikvision training video - how to set up Liveguard.

Here is a quick start guide as to how to configure Acusense cams.

Quick config guide of Acusense function (PDF)

https://cdn.shopify.com/s/files/1/0666/0925/0361/files/Quick-Start-Guide-of-AcuSense-Solutions-20191120.pdf?v=1720081262

Note - if you aren't getting push notifications, go back to the NVR (not the camera), and make sure NOTIFY SURVEILLANCE CENTRE is enabled for that camera. Then go back to STEP 5 and save the lines on the camera again.

Back to blog